![]() The exclusive jump starting terminal is to be used when charging the 12 volt battery from another vehicle in an emergency. ![]() L Do not allow children near the 12 volt battery.Ī notice n To prevent damaging the vehicle L Always wash your hands after handling the battery support, terminals, and other battery-related parts. Place a wet sponge or cloth over the affected area until medical attention can be received. L In the event that battery fluid comes into contact with the skin or eyes, immediately wash the affected area with water and seek medical attention. L When working with the 12 volt battery, always wear safety glasses and take care not to allow any battery fluids (acid) to come into contact with skin, clothing or the vehicle body. Observe the following precautions when handling the 12 volt battery: The 12 volt battery contains poisonous and corrosive acidic electrolyte, while related parts contain lead and lead compounds. L Do not allow open flame or use matches, cigarette lighters or smoke near the 12 volt battery. L Do not allow the jumper cables to come into contact with the "+" and "-" terminals. L Make sure the jumper cable is connected to the correct terminal and that it is not unintentionally in contact with any part other than the intended terminal. Observe the following precautions to prevent accidentally igniting the flammable gas that may be emitted from the 12 volt battery. N Avoiding 12 volt battery fires or explosions N When the 12 volt battery is removed or discharged L Turn off any unnecessary electrical components when the vehicle is running at a low speed for an extended period, such as in heavy traffic, etc. N Avoiding a discharged 12 volt battery l Turn off the headlights and the audio system while the hybrid system is turned off. In addition, the shift position may not changed from "P". The hybrid system cannot be started by push-starting. N Starting the hybrid system when the 12 volt battery is discharged Once the hybrid system starts, have the vehicle checked at your Toyota dealer as soon as possible. step]! Once the vehicle's hybrid system has started, remove the jumper cables in the exact reverse order in which they were connected. If the indicator does not come on, contact your Toyota dealer. Step]7 Make sure the "READY" indicator comes on. step]! Maintain the engine speed on the second vehicle and turn the "POWER" switch to ON mode, then start your vehicle's hybrid system. STEPI5 Turn the "POWER" switch to ACCESSORY mode. Increase the engine speed slightly and maintain at that level for approximately 5 minutes to recharge the 12 volt battery of your vehicle. Step| 4 Start the engine of the second vehicle. □ Connect the jumper cable to ground on your vehicle as shown in the illustration. □ Positive (+) battery terminal on the second vehicle B Negative (-) battery terminal on the second vehicle □ Exclusive jump starting terminal on your vehicle Open the exclusive jump starting terminal cover. If you have a set of jumper (or booster) cables and a second vehicle with a 12 volt battery, you can jump start your Toyota following the steps below. You can call your Toyota dealer or qualified repair shop. The following procedures may be used to start the hybrid system if the vehicle's 12 volt battery is discharged.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |